Model making time has been at a bit of a premium at the moment but I have grabbed the odd few minutes here and there to get some progress on the model bridge I am building. Having got the two sides fasten together it was time to infill the top of the bridge arch. As this is a semi curved area, I cut several lines part way through the card infill on its upper surface where it needed to curve. The picture probably explains better than my words!
I also cut out some additional cross members to strengthen the structure. Gluing everything in place I used masking tape to hold everything in place until the glue sets.
Once set in a day or so I can start looking at getting a top on it and some brick papers.
No comments:
Post a Comment